HOMAG Edgeteq 4.4 AT airTec Edgebander (LOW HOURS)

-powerTouch Program Control
-electrical equipment installed per UL regulations
-motorized top pressure beam for workpiece thickness adjustment
-panel preheating
-automatic feed track lubrication system
-extended infeed fence with servo control
-pneumatically-controlled hard stop at machine infeed to prevent premature workpiece introduction
-Joint Trimming Unit for pre-trimming the workpiece edge prior to processing

-QA-65 N granulate glue application system for use with EVA and PUR adhesives, with purge feature.
-software pre-installation for anti-adhesive, lubrication, and detergent spraying units
-motorized positioning of the pressure zone. First pressure roller driven and two (2) idle pressure rollers
-AT 15 airTec Unit to provide zero glue line results. Maximum workpiece thickness is 40 mm when using airTec.
-Double-Motor End Trimming Unit with straight and chamfer capability. Chamfer up to 15 degrees. Program-controlled indexing from straight to bevel end trimming
-MS 40 Multi-Stage Fine Trimming Unit with 4 processing positions via program control: 2 radii, bevel and flush trimming. Servo control for edge thickness. Nested top copy system with 3 roller tracing. (R = 1 / 2 mm)
-Corner Rounding Unit with 2 position indexing automatically for two edge thicknesses. (R = 2 mm)
-MZ 40 Multi-Stage Scraping Unit with program control for two (2) different radii and bevel scraping: servo-controlled vertical and horizontal tracing rollers. Nested top and bottom copy system with 3 roller tracing. (R = 1 / 2 mm)
-Finish Scraping Unit
-Buffing Unit with two (2) motors, two (2) cloth buffing discs (150 x 20 mm diameter)
-sound enclosure with window
-extendable workpiece support track
-electronic frequency changer for all trimming motors – including electronic motor braking
-isolation transformer with variable infeed voltage for balancing all three (3) phases of incoming power and increasing the lifetime of the machine’s electrical components
-TFU 120 Connection Kit