- sold -
USED MACHINE SPECIFICATION:Machine Type/Model:
Used brandt Brandt KD-78 2C Edge Bander with pre-mill & corner rounding
- Line control (NO limit switches) for workstation function.
- Pressure beam height adjustment for all work stations via digital height indicator.
- ”PC-16” Program Control with: 7-1/2” VGA Screen, 8 MB IDE flash disk, 8 MB RAM.
- Signal infeed light to insure proper spacing between panels.
- 2-Motor Pre-Mill unit with diamond cutterheads.
- Quick heat-up glue system,(approx. 10 Min) w/hopper feeder & w/glue tank for maintenance & quick glue color change; glue temperature indicator for both the glue pot & glue roller with LED thermostat & automatic temperature reduction if the machine is idle for (15) Min or more. The glue applicator roller is also reversible & retractable from the fence line.
- Automatic magazine for strip & coil (large coil table 800 mm dia. to accommodate large coils of 3 mm PVC stock, 3 mm PVC guillotine, (1) drive plus (1) split secondary roller ”pneumatically controlled” pressure sections.
- End trim chamfers 0° - 15° via programmable controller.
- Top & bottom flush/radius trim, bevels 0° - 15° with insert knives for 3 mm PVC radius.
- Top & bottom fine trim with DFC cutterhead & Servo motor controlled positioning of the work unit & side copy to edge thickness, horizontal & vertical tracing wheels; bevels 0° - 15° with insert knives for 3 mm PVC radius.
- Contour trimming station for corner rounding for front & trailing corners on-the-fly.
- Top & bottom profile scraping for 3 mm radius, pneumatically controlled indexing system.
- Top & bottom flat finish scraping unit for finish scraping of panel.
- Top & bottom buffing with manual tilt.
- Operator control panel w/PLC (Programmable Logic Control) keypad & LED readouts.
- End trim, flush trim & fine trim stations have High Frequency motors w/electronic brakes.
|Edge capacity||0.4 - 1/2" edge capacity|
|Panel thickness||5/16" - 2-3/8"|
|Minimum width panel||2-3/8"|
|Feed speed ||36 or 52 FPM
|Feed motor||3 HP|
|Pre-Milling unit||2 x 3 HP motors, 12,000 RPM
|End trim unit||0.5 HP - 12,000 RPM motors|
|Swiveling range||Chamfers 0° - 15°
|Flush trim unit||0.75 hp - 12,000 RPM motors|
|Bevel range||0° - 30°
|Fine trim unit||0.75 hp - 12,000 RPM motors|
|Insert positions||Flush/3mm radius/Bevel 0° - 15°|
|Corner rounding unit||0.5 HP - 12,000 RPM motors|
|Profile scraping||3 MM radius|
|Buffing unit||0.25 HP - 1,400 RPM motors|
- Can be seen in operation. available August 2014.
- All machines are quoted fob their present location
- Crating, teardown, loading, rigging & re-assembly are not included.
- Specifications & conditions are subject to change without notice and are not guaranteed to be accurate. Machines are sold as is where is.
- Machines are subject to prior sale without advanced notice.